Eaton Cooper Power Systems LCR 6200 RFN Instructional Leaflet page 3

SAFETY
FOR LIFE
LCR 6200 RFN Regulatory Notices
WARNING The Original Equipment Manufacturer (OEM) must ensure that FCC Labeling requirements are met. This
includes a clearly visible label on the outside of the OEM enclosure specifying the Eaton's Cooper Power Systems
FCC identifier (FCC ID: P9X-RFNSCOMMMR3) and IC Number (IC: 6766A-RFNSCOMMMR3) as well as the FCC
Notice below.
WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
As such, the radio component of this device is intended only for OEM integrators under the following two conditions:
1. This device may not cause harmful interference, and
2. The transmitter module may not be co-located with any other transmitter or antenna.
WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING The installer of this radio equipment must ensure that the antenna is located or pointed such that it does
not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from
Health Canada's Web site: www.hc-sc.gc.ca.
WARNING To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operate
in conjunction with any other antenna or transmitter.
As such, the radio component of this device is intended only for OEM integrators under the following two conditions:
• The antenna must be installed such that 20 cm is maintained between the antenna and users.
• The transmitter module may not be co-located with any other transmitter or antenna.
As long as the two conditions above are met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end product for any additional compliance requirements required with
this module installed (e.g., digital device emissions, PC peripheral requirements).
In the event that these conditions cannot be met (for example, co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be installed such that 20 cm
may be maintained between the antenna and users (for example access points, routers, wireless ASDL modems,
certain laptop configurations, and similar equipment). The final end product must be labeled in a visible area with
the following: "Contains FCC ID: P9X-RFNSCOMMMR3, IC: 6766A-RFNSCOMMMR3".
The radio component is an integral part of the LCR 6200 RFN and it cannot be removed.
Eaton's Cooper Power Systems
CT-Y0-0558
3