Assembling The Base - Axkid Babyfix base Instruction Manual

Assembling The Base

Attach the belt lock-off clip (L) to the backrest (A). Insert the two tubing ends of the backrest into the two
1
holes at the rear of the base. Ensure the backrest is pushed down into the base and then secure the
backrest using screws (N). Tighten the screws using a Phillips screwdriver (not supplied).
Allowed And Disallowed Positioning Of The Base
The Babyfix base can be used on any forward facing passenger seat which has ISOFIX brackets or
2
which has a 3-point seat belt (i), so long as there is no active airbag in place. The child restraint cannot
be used with a 2-point lap belt (ii).
IMPORTANT: If you wish to install your Babyfix base in a location where an airbag is fitted, then the airbag
must be disconnected at an authorized service centre. Some vehicles may be equipped with a switch which
allows you to manually switch the airbag off. It is important to always check if the vehicle' s indicator light shows
that the airbag is turned off.
WARNING: Never use on a seat with an active airbag
WARNING: Never use on rearward or side facing vehicle seats
WARNING: Air bags are designed for adults and can seriously harm your child in a crash.
Allowed and disallowed positioning of the Babyfix base.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward facing seat with 3-point seat belt
Seat with 2-point seat belt
Forward facing seat with ISOFIX brackets
Side facing seats
Rear facing seats
Never install a child restraint in a passenger seat
where an active airbag is fitted.
5
Yes
NO
Yes
NO
Yes
NO
NO