Table of Contents
Advertisement
5) Each unit has 5 modes to be used in daisy chain system.
1. Main Device
Under this Mode, it will display the video source from the Main HDMI input (also called
'local data) in the front of device.
This mode will define the device as the master unit in the system. There should be only one master device in
one system. Normally the first unit is always used as Main Device.
2. Slave(get local data, transfer local data)
This mode enables the devices to have frame lock with the master device and output the signal from its
own input. It will then transfer its own input source to next device.
3. Slave(get Cascade data, transfer local data)
This mode enables the devices to have frame lock with the master device and output the signal from
master device via HDMI daisy chain. However it will transfer the input source from its own input to next
device.
4. Slave(get local data, transfer Cascade data)
This mode enables the devices to have frame lock with the master device, but output the signal from its
own input. It will however then transfer the input source from master device.
5. Slave(get Cascade data, transfer Cascade data)
This mode enables the devices to have frame lock with the master device and output and transfer the signal
from the input source of master device.
6) Change the unit from Slave mode to Master mode
Double click on the device image in 'Device' of management software to open full 'Change Device Mode'
dialog window and then choose 'Main Device' mode to set the unit back to Master mode.
Show Red Header
Show Purple Header
Show Green Header
Show Blue Header
Show Grey Header
Advertisement
Table of Contents
