Table of Contents
Advertisement
(5)
Fasten the mounting bracket assembly to install outdoor unit on the mast
Connect the antenna to the N-male connector port labeled
(6)
antenna installation, use the HDF 400 RF coaxial cable. The polarization of antenna for both BU and RU should
be the same; otherwise, the installation will fail to communicate. At the same time, you have to point the
directional antenna to that of the other unit.
Notice: The antenna must be installed by the professional installer to comply with the safety, electrical and radiation standards.
The installer should properly configure the output power of transceiver according to related country regulation requirement and per
antenna type.
Attach the end of 8-pin male connector of category-5 cable to the 8-pin female connector port labeled
outdoor unit. Then, the outdoor unit installation is completed.
Hardware Installation
.
Figure 2-17 Install Outdoor Unit to the Mast
Figure 2-18 Install Antenna to the Outdoor Unit
A-6000 High Speed, Long Range Ethernet Wireless Bridge
on the top of outdoor unit. For the directional
on the bottom of
2-7
Advertisement
Table of Contents
