Figure 2-10 Network/Power Injector; Figure 2-11 Antenna Alignment Kit (Ak-100) - ZyXEL Communications ZyXEL ZyAIR A-6000 User Manual

7. Mounting bracket
The mounting kit is used to provide a good support for the outdoor unit and the flat panel antenna. Please
follow the installation procedure to mount the outdoor unit and the flat panel antenna. The contents of the
mounting kit are shown below.
8. Network/Power Injector
The network /power injector is used to combine the data stream and power into one cable. It has three ports.
The port named POWER is for 15V power from the switching power adapter. The port named TO LAN is
connected the customer premises equipment (CPE) by Cat-5 cable. The port named TO RADIO is
connected to the outdoor unit by the cable described in item 5.
The appearance of the network/power injector is shown below.
9. Antenna Alignment Kit
Two flat panel antennas of the A-6000 should be well aligned before the normal operation. If the antenna
alignment is not well done, the received signal strength will be small and the link quality will be not good
enough to support high-speed data communication. The antenna alignment kit is connected to the outdoor
unit through the RS-232 cable. You should modify the vertical and horizontal angle of the panel antenna
according to the signal strength indicated on the AK-100. The outward appearance of the antenna alignment
is shown below.
Hardware Installation
Figure 2-10 The Mounting kit

Figure 2-10 Network/Power Injector

Figure 2-11 Antenna Alignment Kit (AK-100)

A-6000 High Speed, Long Range Ethernet Wireless Bridge
2-4