ZyXEL Communications ZyXEL ZyAIR A-6000 User Manual page 35

-> get gateway
Gateway IP Address:
-> set gateway 192.168.0.1
Gateway IP Address: 192.168.0.1
(5) To display hardware
Use the get hardware command to display the vendor ID and chip (MAC, PHY and analog) revisions.
-> get hardware
PCI Vendor ID: 0x168c, Device ID: 0x207, Sub Vendor ID: 04, Sub Device
ID: 0
WLAN revisions: mac 3.0 phy 2.0 analog 1.6
(6) To display platform hardware version
Use the get hardware command to display the vendor ID and chip (MAC, PHY and analog) revisions.
-> get hw_ver
A-6000 System Hardware Platform: 1.00a
(7) To display/modify IP address
Use the get/set ipaddr command to display or modify the basestation unit IP address.
-> get ipaddr
IP Address: 192.168.1.20
-> set ipaddr 192.168.1.40
IP Address: 192.168.1.40
(8) To display/modify IP subnet mask
Use the get/set ipmask command to display or modify the basestation unit IP subnet mask.
-> get ipmask
IP Subnet Mask: 255.255.255.0
-> set ipmask 255.255.0.0
IP Subnet Mask: 255.255.0.0
(9) To display security policy
Use the set security command to view or modify the authentication type.
wlan0 -> get security
Security Policy: AES.
wlan0 -> set security TKIP
Security Policy: TKIP
(10) To modify security policy
Use the set security command to view or modify the authentication type.
wlan0 -> set security AES
Security Policy: AES.
wlan0 -> set security TKIP
Security Policy: TKIP
(11) Security Key Configuration
Sets the PSK passphrase. Hit return at the old passphrase prompt and enter the new passphrase. Maximum is
63 characters. For examples:
-> set passphrase
Old PassPhrase: 12345678
(12) System Configuration
Following table lists the steps to configure the system. Remember to reboot the system to make configuration
works.
Command
set factory
set ipaddr <IP Address>
CLI commands
Description
Sets the BU to factory defaults.
Sets the IP address of the BU ethernet interface
A-6000 High Speed, Long Range Ethernet Wireless Bridge
4-2