Assembly; Appliance Installation; Power Connection - AEG VH 206 Operating And Installation Instructions

8.

Assembly

8.1

Appliance installation

To secure the appliance, proceed as follows:
»
Unpack the appliance carefully.
»
Drill the fixing holes in accordance with the dimensioned drawing in the chapter "Specification".
»
Insert the rawl plugs. The rawl plugs supplied are suitable for solid walls. For other wall structures, suitable rawl plugs
must be provided on site.
»
Insert the first screw into the top hole drilled in the wall, leaving approx. 3 mm of the screw protruding. Then hook the
appliance into the gap between the wall and the screw head.
»
Using the second screw, secure the additional wall retainer, located at the lower rear part of the appliance, to the wall.
The appliance can now no longer be removed from the wall.
8.2

Power connection

»
Select a power cable with an adequate cross-section. Install a socket for permanent power supply at a distance of at least
10 cm from the side of the appliance.
The power cable must not touch the appliance. Trim it so it leads directly to the socket. Then strip the wires and cut the cores
to size.
Installation - for contractors
25