Table of Contents
Advertisement
The following safety instructions apply to the Prestige:
Be sure to read and follow all warning notices and instructions.
The maximum recommended ambient temperature for the Prestige is 40º(104º). Care must be taken to allow
sufficient air circulation or space between units when the Prestige is installed inside a closed rack assembly.
The operating ambient temperature of the rack environment might be greater than room temperature.
Installation in a rack without sufficient airflow can be unsafe.
Racks should safely support the combined weight of all equipment.
The connections and equipment that supply power to the Prestige should be capable of operating safely with
the maximum power requirements of the Prestige. In case of a power overload, the supply circuits and supply
wiring should not become hazardous. The input rating of the Prestige is printed on the nameplate.
The AC adapter must plug in to the right supply voltage, i.e. 120VAC adapter for North America and 230VAC
adapter for Europe. Make sure that the supplied AC voltage is correct and stable. If the input AC voltage is
over 10% lower than the standard may cause the Prestige to malfunction.
Installation in restricted access areas must comply with Articles 110-16, 110-17, and 110-18 of the National
Electrical Code, ANSI/NFPA 70.
Do not allow anything to rest on the power cord of the AC adapter, and do not locate the product where
anyone can walk on the power cord.
Do not service the product by yourself. Opening or removing covers can expose you to dangerous high voltage
points or other risks. Refer all servicing to qualified service personnel.
Generally, when installed after the final configuration, the product must comply with the applicable safety
standards and regulatory requirements of the country in which it is installed. If necessary, consult the
appropriate regulatory agencies and inspection authorities to ensure compliance.
1. A rare condition can create a voltage potential between the earth grounds of two or more buildings. If
products installed in separate building are interconnected, the voltage potential can cause a hazardous
condition. Consult a qualified electrical consultant to determine whether or not this phenomenon exists and,
if necessary, implement corrective action before interconnecting the products. If the equipment is to be used
with telecommunications circuit, take the following precautions:
Never install wiring during a lightning storm.
Never install jacks in wet location unless the jack is specially designed for wet location.
Never touch uninsulated wires or terminals unless the line has been disconnected at the network interface.
Use caution when installing or modifying lines during an electrical storm. There is a remote risk of electric
shock from lightning.
Safety Instructions
Important Safety Instructions
Prestige 964 Cable Router
Appendix B
C
Advertisement
Table of Contents
