Figure 8-8 Restore Using Ftp Session Example; Restore Via Console Port; Figure 8-9 System Maintenance - Restore Configuration; Figure 8-10 System Maintenance - Starting Xmodem Download Screen - ZyXEL Communications Prestige 782M User Manual

Step 7. Use "put" to transfer files from the Prestige to the computer, for example, "put config.rom rom-
0" transfers the configuration file "config.rom" on your computer to the Prestige. See earlier in
this chapter for more information on filename conventions.
Step 8. Enter "quit" to exit the ftp prompt. The Prestige will automatically restart after a successful
restore process.
8.3.2 Restore Using FTP Session Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to section 0 to read about configurations that disallow TFTP and FTP over WAN.

8.3.3 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter "y" at the following screen.
Figure 8-9 System Maintenance — Restore Configuration
Step 2.
The following screen indicates that the Xmodem download has started.
Figure 8-10 System Maintenance — Starting Xmodem Download Screen
Step 3.
Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
Firmware and Configuration File Maintenance

Figure 8-8 Restore Using FTP Session Example

Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...
CCCCCCCCC
P782M G.SHDSL Bridge
8-9