Editing Ppp Options; Remote Node Setup; Figure 4-3 Menu 11.2 - Remote Node Ppp Options; Table 4-2 Remote Node Ppp Options Menu Fields - ZyXEL Communications Prestige 782M User Manual

the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.

4.1.4 Editing PPP Options

To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu 11.1 —
Remote Node Profile, use [SPACE BAR] to select Yes and then press [ENTER] to open menu 11.2, as
shown next.
Press Space Bar to Toggle.
The following table describes the menu 11.2 and how to configure the PPP options.
FIELD
Encapsulation
Compression
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC] to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.2

Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 — Remote Node Network
Layer Options as shown next.
Remote Node Configuration
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
Press ENTER to Confirm or ESC to Cancel:
Figure 4-3 Menu 11.2 — Remote Node PPP Options

Table 4-2 Remote Node PPP Options Menu Fields

Select Standard PPP. Select CISCO PPP only if
the node is a Cisco computer.
Turn on/off Stac Compression. The default is No.
DESCRIPTION
P782M G.SHDSL Bridge
OPTIONS
Standard PPP
CISCO PPP
Yes/No
4-5