Problems With The Password; Problems With The Dsl Led; Problems With The Lan Interface; Table 36Troubleshooting The Password - ZyXEL Communications P-660R-Tx v2 Series User Manual

P-660R-Tx v2 Series User's Guide

13.3 Problems with the Password

Table 36 Troubleshooting the Password
PROBLEM
I cannot
access the
ZyXEL Device.

13.4 Problems with the DSL LED

Table 37 Troubleshooting the DSL LED
PROBLEM
The DSL LED is
off.

13.5 Problems with the LAN Interface

Table 38 Troubleshooting the LAN Interface
PROBLEM
I cannot access the
ZyXEL Device from
the LAN.
I cannot ping any
computer on the LAN.
118
CORRECTIVE ACTION
The default password is "1234". The Password field is case-sensitive. Make sure that
you enter the correct password using the proper case.
If you have changed the password and have now forgotten it, you will need to upload
the default configuration file (Refer to
35). This restores all of the factory defaults including the password.
CORRECTIVE ACTION
Check the telephone wire and connections between the ZyXEL Device DSL port
and the wall jack.
Make sure that the telephone company has checked your phone line and set it up
for DSL service.
Reset your ADSL line to reinitialize your link to the DSLAM. For details, refer to
Chapter 12 on page 103
CORRECTIVE ACTION
If the 10M/100M LEDs on the front panel are both off, refer to
page 117.
Make sure that the IP address and the subnet mask of the ZyXEL Device and
your computer(s) are on the same subnet.
If the 10M/100M LEDs on the front panel are both off, refer to
page 117.
Make sure that the IP address and the subnet mask of the ZyXEL Device and
the computers are on the same subnet.
Section 2.2 on page 36
(web configurator).
in Chapter 2 on page
Section 13.2 on
Section 13.2 on
Chapter 13 Troubleshooting