Step 3: Install The Vp-427Uhd; Step 4: Connect The Inputs And Outputs; Step 5: Connect The Power; Step 6: Operate The Vp-427Uhd - Kramer VP-427UHD Quick Start Manual

# Feature
14 AUDIO OUT 5-pin Terminal
Block Connector
15 S/PDIF digital audio output
16 IR 3.5mm Mini Jack
17 Ethernet RJ-45 Connector
18 RS-232 Terminal Block
Connector
19 12V DC
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Step 3: Install the VP-427UHD

Install VP-427UHD using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/VP-427UHD
(see

Step 4: Connect the inputs and outputs

Always switch OFF the power on each device before connecting it to your VP-427UHD. For best results, we recommend that
you always use Kramer high-performance cables to connect AV equipment to the VP-427UHD.
For optimum range and performance use the recommended Kramer cables available at
www.kramerav.com/product/VP-427UHD

Step 5: Connect the power

Connect the 12V DC power supply to VP-427UHD into the mains electricity. When the connected transmitter provides PoE for the
VP-427UHD, you do not need to connect it to the 12V DC power supply.
Safety Instructions
Caution: There are no operator serviceable parts inside the unit.
Warning: Use only the power cord that is supplied with the unit.
Warning: Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning: Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information

Step 6: Operate the VP-427UHD

Operate the VP-427UHD:
•
Toggle the HDBT/HDMI front panel
button to select the input.
•
Control device via OSD menu or remotely
by RS-232 serial commands or Ethernet
transmitted by a touch screen system,
PC, or other serial controller.
•
Control remote devices on the
transmitter via RS-232, IR or Ethernet
signal extension.
Function
Connect to a balanced or unbalanced stereo audio acceptor.
Connect to a digital audio acceptor.
Connect to an IR Sensor (in) or Emitter (out) to control a remote device.
Connect via a LAN to a PC to control the VP-427UHD and/or extend Ethernet signals to the
HDBT transmitter via the HDBT IN port.
Connects to a controller to control the VP-427UHD or to extend RS-232 signals between the
VP-427UHD and the RS-232 port of the connected HDBT transmitter.
+12V DC connector for powering the unit.
www.kramerav.com/downloads/VP-427UHD
).
RS-232 Control / Protocol 3000?
Baud Rate:
Data Bits:
Example: (get device model): #MODEL?<CR>
Default Ethernet Parameters
IP Address:
Subnet mask:
.
115,200 Parity:
8 Command Format:
192.168.1.39 UDP Port #:
255.255.0.0 TCP Port #:
Connect AUDIO OUT
To a balanced stereo
audio acceptor:
To an
unbalanced
stereo audio
acceptor:
None Stop Bits: 1
ASCII
50000 Gateway: 0.0.0.0.
5000