Kohler LOURE 14676A Installation Instructions

Download this manual

INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN

All information is based on the latest product information available at the time of publication. Kohler Co.

reserves the right to make changes in product characteristics, packaging, or availability at any time without

notice.

Please leave these instructions for the consumer. They contain important information.

NOTES:

1. The installer must provide a G1/2" male supply fitting(1), protruding 15mm out from the face of the

finished wall.

2. Flush the water supply pipes thoroughly to remove any debris.

3. An in line water filter must be used with this product.

4. Inspect the supply pipes for damage. Replace as necessary.

5. Observe local plumbing codes.

Check for leaks before covering the pipes, repair as needed.

7. Recommended working pressure: 100 to 500kPa.

8. Maximum working pressure: 800kPa.

9. All installations should comply with the relevant requirements of AS/NZS 3500.

ROUGH-IN DIMENSIONS

121

1154542-AN2-B

12/04/2016

BATH TAPWARE

LOURE

Bath Spout - Wall Mount

Bath spout - Wall mount: 14676A

243

Fringe of bath

Page 1 Bath spout - Wall mount: 14676A BEFORE YOU BEGIN All information is based on the latest product information available at the time of publication. Kohler Co. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice.
Page 2 Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc. which could adversely affect the finish and are not recommended for cleaning. Do not use abrasive cleaners or solvents on Kohler fittings. **Color code must be specified when ordering...