Resetting The G-560; Method Of Restoring Factory-Defaults; Table 2 Factory Defaults - ZyXEL Communications 802.11g Wireless Access Point ZyXEL G-560 User Manual

Note: The wireless stations and G-560 must use the same SSID, channel and
wireless security settings for wireless communication.
If you do not enable any wireless security on your G-560, your network traffic is
visible to any wireless networking device that is within range.

2.4 Resetting the G-560

If you forget the G-560's IP address or your password, to access the G-560, you will need to
reload the factory-default using the RESET button. Resetting the G-560 replaces the current
configuration file with the factory-default configuration file. This means that you will lose all
configurations that you had previously. The following parameters will be reset to the default
values.

Table 2 Factory Defaults

PARAMETER
IP Address
Password
Wireless Security
SSID

2.4.1 Method of Restoring Factory-Defaults

You can erase the current configuration and restore factory defaults in two ways:
1 Use the RESET button on the G-560 to upload the default configuration file (hold this
button in for about 10 seconds or release the button when the PWR LED starts blinking).
2 Use the web configurator to restore defaults. Click SYSTEM > Management >
Configuration File. From here you can restore the G-560 to factory defaults.
Chapter 2 Management Computer Setup
DEFAULT VALUE
192.168.1.2
1234
Disabled
ZyXEL
ZyXEL G-560 User's Guide
35