ZyXEL Communications 802.11g Wireless Access Point ZyXEL G-560 User Manual page 65

Table 11 Wireless Settings: Access Point + Bridge (continued)
Channel
Wireless Mode
#
Remote Bridge(s)
MAC Address
(BSSID)
Advanced Settings
RTS/CTS
Threshold
Fragmentation
Threshold
Enable Intra-BSS
Traffic
Number of
Wireless Stations
Allowed to
Associate:
Output Power
Management
Chapter 6 Wireless Screens
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
Refer to the chapter on wizard setup for more information about channels.
Select Pure B Mode to allow only IEEE 802.11b compliant WLAN devices to
associate with the G-560.
Select Pure G Mode to allow only IEEE 802.11g compliant WLAN devices to
associate with the G-560.
Select Mixed Mode to allow either IEEE 802.11b or IEEE 802.11g compliant
WLAN devices to associate with the G-560. The transmission rate of your G-560
might be reduced.
Select G+ to allow any ZyXEL WLAN devices that support this feature to associate
with the G-560. This permits the G-560 to transmit at a higher speed than the pure
G mode.
Select B+ to allow any ZyXEL WLAN devices that support this feature to associate
with the G-560. This permits the G-560 to transmit at a higher speed than the pure
B mode.
This is the index number of the bridge connection.
Type the MAC address of the peer device in a valid MAC address format, that is,
six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Select the check box and enter a value between 0 and 2432. The default is 2432.
You must enter 4096 if you select G+ in the Wireless Mode field.
Select the check box and enter a value between 256 and 2432. The default is
2432. It is the maximum data fragment size that can be sent.
You must enter 4096 if you select G+ in the Wireless Mode field.
Intra-BSS traffic is traffic between wireless stations in the same BSS. Select this
check box to enable Intra-BSS traffic.
Use this field to set a maximum number of wireless stations that may connect to
the G-560.
Enter the number (from 1 to 32) of wireless stations allowed.
Set the output power of the G-560 in this field. If there is a high density of APs
within an area, decrease the output power of the G-560 to reduce interference with
other APs.
The options are Full, 50%, 25% and 12%.
ZyXEL G-560 User's Guide
65