Bridge/Repeater Mode - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

G-3000H User's Guide
Table 14 Wireless: Access Point
LABEL
Hide Name
(SSID)
Enable Intra-
BSS Traffic
Enable
Breathing LED
Enable
Spanning Tree
Control (STP)
Output Power
Preamble
802.11 Mode
Max. Frame
Burst
Apply
Reset

5.6.2 Bridge/Repeater Mode

The ZyAIR can act as a wireless network bridge and establish wireless links with other APs.
You need to know the MAC address of the peer device, which also must be in bridge mode.
The ZyAIR can establish up to five wireless links with other APs.
66
DESCRIPTION
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Intra-BSS traffic is traffic between wireless stations in the same BSS. Select this
check box to enable Intra-BSS traffic.
Select this check box to enable the Breathing LED, also known as the ZyAIR LED.
The blue ZyAIR LED is on when the ZyAIR is on and blinks (or breaths) when data is
being transmitted to/from its wireless stations.
Clear the check box to turn this LED off even when the ZyAIR is on and data is being
transmitted/received.
(R)STP detects and breaks network loops and provides backup links between
switches, bridges or routers. It allows a bridge to interact with other (R)STP -
compliant bridges in your network to ensure that only one path exists between any
two stations on the network. Select the check box to activate STP on the ZyAIR.
Set the output power of the ZyAIR in this field. If there is a high density of APs within
an area, decrease the output power of the ZyAIR to reduce interference with other
APs. Select one of the following 100%(Full Power), 50%, 25% or 12.5%. These
percentages represent the following power ranges;
• 100%(Full Power) <11b>17dBm/<11g>13dBm (<11b>50mW/<11g>20mW),
• 50% <11b>15dBm/<11g>11dBm (<11b>32mW/<11g>12.6mW),
• 25% <11b>13dBm/<11g>9dBm (<11b>20mW/<11g>7.9mW),
• 12.5% <11b>11dBm/<11g>7dBm (<11b>12.6mW/<11g>5mW).
Select a preamble type from the drop-down list menu. Choices are Long, Short and
Dynamic.
See the section on preamble for more information.
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the ZyAIR.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the ZyAIR.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices
to associate with the ZyAIR. The transmission rate of your ZyAIR might be reduced.
Enable Maximum Frame Burst to help eliminate collisions in mixed-mode networks
(networks with both IEEE 802.11g and IEEE 802.11b traffic) and enhance the
performance of both pure IEEE 802.11g and mixed IEEE 802.11b/g networks.
Maximum Frame Burst sets the maximum time, in microseconds, that the ZyAIR
transmits IEEE 802.11g wireless traffic only.
Type the maximum frame burst between 0 and 1800 (650, 1000 or 1800
recommended). Enter 0 to disable this feature.
Click Apply to save your changes back to the ZyAIR.
Click Reset to begin configuring this screen afresh.
Chapter 5 Wireless Configuration