F/W Upload Screen; Figure 94 Firmware Upload; Table 57 Firmware Upload - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

G-3000H User's Guide
Table 56 Channel Usage
LABEL
Network Mode
Refresh

14.5 F/W Upload Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
"*.bin" extension, e.g., "zyair.bin". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
See the Firmware and Configuration File Maintenance chapter for upgrading firmware using
FTP/TFTP commands.
Click MAINTENANCE and then F/W Upload. Follow the instructions in this screen to
upload firmware to your ZyAIR.

Figure 94 Firmware Upload

The following table describes the labels in this screen.

Table 57 Firmware Upload

LABEL
File Path
Browse...
Upload
Note: Do not turn off the ZyAIR while firmware upload is in progress!
166
DESCRIPTION
"Network mode" in this screen refers to your wireless LAN infrastructure (refer
to the Wireless LAN chapter) and WEP setup.
Network modes are: Infrastructure (same as an extended service set ESS)),
Infrastructure with WEP (WEP encryption is enabled), Ad-Hoc (same as an
independent basic service set IBSS)), or Ad-Hoc with WEP.
Click Refresh to reload the screen.
Type in the location of the file you want to upload in this field or click Browse ...
to find it.
Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two
minutes.
DESCRIPTION
Chapter 14 Maintenance