Philips AVENT SCF699/17 Manual page 2

For your child's safety and health WARNING!
EN
• Always use this product with adult supervision.
• Never use feeding teats as a soother.
• Continuous and prolonged sipping of fluids will cause
tooth decay.
• Always check food temperature before feeding.
• Keep all components not in use out of the reach of children.
• Do not allow children to play with small parts or walk/run
while using bottles or cups.
• Do not place in a heated oven.
• Heating in a microwave oven may produce localised high
temperatures. Take extra care when you heat up drinks in
a microwave.
• To avoid scalding, allow hot liquids to cool before preparing
the feeds.
• Drinks other than milk and water, such as fruit juices and
flavoured sugary drinks are not recommended.
If they are used, they should be well diluted and only used
for limited periods, not constantly sipped.
• To ensure the bottle functions correctly and to prevent
leakage, always make sure you: remove any debris or
residue that may collect around the rim of the bottle
before assembly, and avoid over-tightening the bottle screw
ring when assembling it onto the bottle.
• Expressed breast milk can be stored in sterilised Philips
Avent polypropylene bottles/containers in the refrigerator
for up to 48 hours (not in the door) or the freezer for up
to 3 months. Never refreeze breast milk or add fresh breast
milk to already frozen milk.
Before first use
• Clean and sterilise the product.
• Place in boiling water for 5 minutes. This is to ensure hygiene.
Clean before each use
• Wash and rinse all parts thoroughly in warm water and
some washing-up liquid, then sterilise using a Philips Avent
steriliser or boil for 5 minutes.
• Wash your hands thoroughly and ensure surfaces are clean
before contact with sterilised components. Do not place
components directly on surfaces that have been cleaned
with antibacterial cleaning agents. Excessive concentration
of cleaning agents may eventually cause plastic components
to crack. Should this occur, replace immediately.
• Plastic material properties may be affected by sterilising and
high temperatures. This can affect the fit of the cap.
• Dishwasher safe – food colourings may discolour components.
Assembling the bottle
• The teat is easier to assemble if you wriggle it upwards
instead of pulling it up in a straight line.
• Make sure you pull the teat through until its lower part is
aligned with the screw ring.
• When you assemble the bottle, make sure you place the
cap horizontally onto the bottle so that the teat sits upright.
• To remove the cap, place your hand over the cap and your
thumb in the dimple of the cap.
Teats
• Inspect before each use and pull the feeding teat in all
directions. Throw away at the first signs of damage or
weakness.
• For hygiene reasons, we recommend replacing teats after
3 months.
• Keep teats in a dry and covered container.
• Do not store a feeding teat in direct sunlight or heat, or
leave in disinfectant (sterilising solution) for longer than
recommended, as this may weaken the teat.
• Make sure you use a teat with the correct flow rate when
you feed your baby.
• Teats are available in newborn, slow, medium, fast and
variable flow rates. Only use Philips Avent Natural teats
with Philips Avent Natural bottles.
• To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your Philips
dealer. You can also contact the Philips Consumer Care
Centre in your country.
Compatibility
• This bottle is not compatible with Philips Avent
bottle warmers.
Για την ασφάλεια και την υγεία του παιδιού
EL
σας ΠΡΟΕΙΔΟΠΟΙΗΣΗ!
• Το προϊόν να χρησιμοποιείται πάντα υπό την
επίβλεψη ενήλικα.
• Μην χρησιμοποιείτε ποτέ τις θηλές ως πιπίλες.
• Η συνεχής και παρατεταμένη κατανάλωση υγρών
μπορεί να προκαλέσει φθορά των δοντιών.