Table of Contents
Advertisement
202
STARTING AND OPERATING
applications. Specific design characteristics
give them a higher center of gravity than
conventional passenger cars.
An advantage of the higher ground clearance is
a better view of the road, allowing you to
anticipate problems. They are not designed for
cornering at the same speeds as conventional
passenger cars any more than low-slung sports
cars are designed to perform satisfactorily in
off-road conditions. Avoid sharp turns or abrupt
maneuvers. As with other vehicles of this type,
failure to operate this vehicle correctly may
result in loss of control or vehicle rollover.
O
-R
D
T
FF
OAD
RIVING
IPS
Side Step Removal — If Equipped
NOTE:
Prior to off-road usage, the side steps should be
removed to prevent damage if so equipped.
1. Remove both nuts and bolt from the
underside of the vehicle for each bracket.
Underside Nuts
2. Remove the side step assembly.
Bumper End Cap Removal
The end caps on your vehicle's front fascia/
bumper can be removed by following the steps
below:
NOTE:
Bumper end caps are removable on steel
fascia/bumper only.
1. Loosen the two bolts that retain the GAWR
bracket (Bolts #1 and #2) to the end cap
using a T45 torx bit screw driver. Do not
remove the bolts.
Bolt #1
Bolt #2
2. Remove the remaining 8 bolts.
3. Gently remove the end cap from the vehicle
and store it where it will not get damaged.
4. Repeat this procedure on the other side.
Advertisement
Table of Contents
