Table of Contents
Advertisement
100
GETTING TO KNOW YOUR VEHICLE
6. Swing the frame bracket around the side of
the rail, and insert the screws from
underneath. Tighten with #40 Torx head
driver until they are snug, being careful not
to cross-thread the screws or overtighten.
Refer to the table above for the appropriate
torque specifications for the door rail
screws.
Step Six
D
F
I
OOR
RAME
NSTALLATION
M
— I
E
ODELS
F
QUIPPED
1. Carefully place the front door rail in the
rubber seal at the top of the windshield,
and line up the holes for the Torx head
screws (two for each door).
2. Swing the frame bracket around the side of
the rail, and insert the screws from
underneath. Tighten with #40 Torx head
driver until they are snug, being careful not
to cross-thread the screws or overtighten.
Refer to the table below for the appropriate
torque specifications for the door rail
screws.
Step Two
T
D
WO
OOR
Target Torque
Specification
For Torx Fas-
teners
79.6 in-lbs
(9 N· m )
Do not overtighten the screws. You can strip
the screws if they are overtightened.
FOLDING WINDSHIELD
Lowering of the windshield is NOT recom-
mended in vehicles equipped with a Power
Sliding Top. Damage will occur to the top as
well as the header seal.
The fold-down windshield on your vehicle is a
structural element that can provide some
protection in some accidents. The windshield
also provides some protection against weather,
road debris and intrusion of small branches and
other objects.
Maximum
Minimum
87.6 in-lbs
71.7 in-lbs
(9.9 N· m )
(8.1 N·m)
CAUTION!
CAUTION!
Advertisement
Table of Contents
