HOLDEN JH CRUZE Owner's Handbook Manual page 336

9 Warning
If the recommended pressure
cannot be reached after
approximately 15 minutes, the
vehicle should not be driven. The
tyre is too severly damaged and
the tyre sealant and air
compressor kit cannot inflate the
tyre. Disconnect and stow the tyre
sealant and air compressor kit
back in its original position.
Contact you Holden Dealer.
Drain excess tyre pressure with
the button over the pressure
indicator.
Do not run the compressor longer
than 10 minutes.
14. Detach the tyre repair kit. Push
catch on bracket to remove
sealant bottle from bracket. Screw
tyre inflation hose to free
connection of sealant bottle. This
prevents sealant from escaping.
Stow tyre repair kit in load
compartment.
15. Remove any excess sealant
using a cloth.
16. Take the label indicating
maximum permitted speed from
the sealant bottle and affix in the
driver's field of view.
17. Continue driving immediately so
that sealant is evenly distributed
in the tyre. After driving approx.
10 km (but no more than 10
minutes), stop and check tyre
pressure. Screw compressor air
hose directly onto tyre valve and
compressor when doing this.
If tyre pressure is more than
20 PSI/138 kPa, set it to the
Vehicle care
correct value. Repeat the
procedure until there is no more
loss of pressure.
If the tyre pressure has fallen
below 20 PSI/138 kPa, the vehicle
must not be used. Seek the
assistance of your Holden Dealer.
18. Stow away tyre repair kit in load
compartment.
Note
The driving comfort of the repaired
tyre is severely affected, therefore
have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least 30
minutes.
The built-in safety valve opens at a
pressure of 100 PSI/690 kPa.
Note the expiry date of the kit. After
this date its sealing capability is not
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant bottle.
Dispose of the bottle as prescribed
by applicable laws.
147