Janome Quilt Maker Pro 20 User Manual page 57

User Manual
To add new bobbin configuration and record bobbin capacity
1. When you are ready to define a new bobbin capacity for a particular type of thread, completely fill a
bobbin with that thread and insert it into the machine.
2. Touch the icon to add a new bobbin. Use the pop-up
keyboard to enter a descriptive name, so you will know
which type of thread this configuration applies to. Close the
pop-up keyboard by touching the arrow in the lower-left
corner of the screen.
3. Touch the Record button. The bobbin capacity value will
reset to zero. Quilt until the bobbin runs out.
 NOTE: The Reset Bobbin button on the Main Screen
shows the bobbin level as you quilt. When you touch the
Reset Bobbin button, it shows the estimated capacity of
the full bobbin. As you quilt, this number counts down.
While you are recording the bobbin capacity of a bobbin,
the number increases as you quilt until it runs out
of thread.
4. Return to the low-bobbin alarm screen and press the Record
button again to stop recording. The number that appears in
the Bobbin Capacity box is an estimate how much thread is
on the bobbin.
5. Estimate how much bobbin thread you think you'll use for
tie-offs and decrease the bobbin capacity by that much.
Press the Minus (–) button to decrease the capacity. Or,
touch the Bobbin Capacity box to pop up an on-screen
number pad and enter the number directly.
6. When you are ready to use a full bobbin with that type of
thread, insert the full bobbin and press the Reset Bobbin
button on the Main screen
www.janome.com
QUILT MAKER PRO 20
57