Janome Quilt Maker Pro 20 User Manual page 22

User Manual
To install the optional rear display
1. Locate four 2.5mm hex screws and the 2.5mm hex wrench. You'll also need a display with the
hinges attached to the bottom row of connectors on the back of the display, plus the USB mini B cable
with 90˚ connector on one end.
 NOTE: If you do not have 2.5mm hex screws then you will have 4-40 screws for the
rear handle bar hinges.
2. Insert the screws into the openings on the
display's metal hinge. Align the screws
in the hinge with the holes on the display
bracket. Use the 2.5mm hex wrench or
Phillips screwdriver as required to fully
tighten the screws.
3. Plug the USB mini B cable with 90˚ end into the
rear display and the straight end into the rear
panel of the machine.
 NOTE: The USB port on the right of the
display is used when updating.
22
QUILT MAKER PRO 20
www.janome.com