Flex CHE 5-40 SDS-max Operating Instructions Manual page 16

Setting operating mode
CAUTION!
Do not change operating mode until the
electric power tool is at a standstill.
 Turn the rotary knob until it audibly
engages in the required operating mode:
1. Hammer drilling
2. Chiselling
3. Setting the chisel position (see below)
NOTE!
The rotary knob must audibly click into
–
place in all positions.
Do not switch on the power tool in
–
the position for setting the chisel
position (3.).
Setting the chisel position
The chisel can be adjusted in 12 positions
(moved 30° in each case).
 Set the rotary knob for operating mode
to the position shown.
 Turn the chisel until the chisel is at
the required angle.
16
 Move rotary knob for operating mode
to the symbol.
Switching on the power tool
 Press and hold down the switch.
Switch off the machine:
 Release the switch.
Safety clutch
CAUTION!
If the safety clutch trips, switch off the power
tool immediately!
The safety clutch disconnects the motor
from the tool if a preset torque limit value
is exceeded. The insertion tool stops.
As a result, the motor and gears are
protected from damage.
CHE 5-40 SDS-max