Zoom Series 1063 User Manual page 25

pulse dialing, the line may not be able to accept
tone-dialed calls. Select Pulse dialing in your
software, or make sure the software dialing prefix is
ATDP (for pulse dialing).
Make sure your communications software and
modem are configured for the same COM port.
Make sure your modem has hung up from the
previous call. Select Hang Up in your software; or
type ATH in terminal mode.
Problem The modem can connect to some modems, but
:
not to others.
Solution A remote modem does not respond because of the
:
extended negotiation process by which modems
determine the best common connection between
them. If this is the case, you may have to disable
part or all of the negotiation process. In the following
table, "protocol" means error correction and data
compression.
To force different communication speeds
Negotiate speed and protocol (default setting)
To force protocol
Dualmode (V.90 or V.92)—56000 bps
V92 only (disable V.90)—56000 bps
V.90 only (disable V.92)—56000 bps
Disable both 56K and autorate on V.34—33600 bps
V.34—33600 bps
V.32bis—14400 bps
V.32—9600 bps
2400 bps
1200 bps
Type these AT
commands and
press Enter
AT &F
AT \N3
AT+MS=V92,1
AT+MS=V92,0
AT+MS=V90,0
AT+MS=V34,1
AT+MS=V34,0
AT+MS=V32B,0
AT+MS=V32,0
AT+MS=V22B,0
AT+MS=V22,0
25