Zoom Series 1063 User Manual page 24

If you typed a command but did not receive an OK
response from your modem, the E0 and Q1
commands may be in effect, disabling echo and
responses. Verify this with the &V command. To
enable echo and responses, type ATE1Q0 and
press Enter.
Problem The modem speaker volume is too low or too
:
high.
Your modem has a small speaker on board that
Solution:
provides audible feedback of dial tones and remote
connection signals ("handshaking"). This is not the
same as the speaker that you may have connected
to your sound card.
If the software allows you to control the volume,
make sure the speaker is enabled and set to a
comfortable volume.
If the software does not have speaker settings, add
one of the AT commands listed below to the
initialization string:
L1 for low volume
L2 for medium volume
L3 for highest volume
M0 to turn the speaker off entirely
For example, if you want the volume low and the
software uses the initialization string AT &F, change
it to AT &F L1.
Problem The modem does not automatically dial a call
:
when you send a Dial command.
Solution Make sure the modem speaker is turned on in your
:
software so that you can hear dialing sounds. Also,
make sure that the phone line is plugged in.
Make sure that you are dialing a valid phone
number, including any required dial prefixes.
If you are using tone dialing on a line that requires
24