Advertisement
Installation Manual
3.0 MECHANICAL INSTALLATION
Installation must be completed by competent persons, in accordance
with good industry practice and should conform to all governing and
statutory bodies i.e. IEE, CIBSE, etc.
3
Removing Front Grille
Remove front grille.
Release 2 screws. Lift grille upwards.
4
Removing Fan Plate
Remove fan plate.
5
Preparing Wall Aperture
Prepare the wall aperture to dimensions shown.
6
Cutting Spacer
A
Cut the spacer to match the walls total thickness
using a fine / medium cut woodsaw.
Nuaire |
Western Industrial Estate
XS6WA 260mm sq.
XS9WA 330mm sq.
XS12WA 410mm sq.
A
|
|
| nuaire.co.uk
Caerphilly
CF83 1NA
7
Fitting Temporary Cross Brace
Fit the temporary cross brace across wall sleeve's
outer end to support the sides during installation.
8
Fitting Polystyrene Former
Make hole for
supply cable
Locate the temporary plug to support the other end.
9
Fitting Wall Sleeve
OUTSIDE
IMPORTANT !
Install the sleeve
at a slight angle
(lower to outside)
When fitting the sleeve, introduce a slight downward slope
to the outside, to encourage any water to drain to outside.
10
Making Walls Good
Temporary
crossbrace
Supply wire
inside sleeve
Make good around
the wall sleeve.
18. 03. 20. Document Number 671051
XS WA
Polystyrene
former fits
temporarily
into sleeve end.
INSIDE
Make good
the inside and
outside walls
flush with the
sleeve.
Polystyrene former
supporting sleeve
end.
3
Advertisement
