Maintenance And Repair; Battery Replacement - Fluke 945 User Manual

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the problem.
1. Check the battery. Replace the battery immediately when the symbol "�"
appears on the LCD.
2. Review the operating instructions for possible mistakes in operating
procedure.
Except for the replacement of the battery, repair of the meter should be performed
only by a Factory Authorized Service Center or by other qualified instrument
service personnel. The front panel and case can be cleaned with a mild solution of
detergent and water. Apply sparingly with a soft cloth and allow to dry completely
before using. Do not use aromatic hydrocarbons or chlorinated solvents for
cleaning.

BATTERY REPLACEMENT

1. Turn off the meter and slide out the battery cover. Replace the battery with a
NEDA type 1604 (IEC 6LR61) or equivalent 9V alkaline battery. Replace the
cover.
2. Remove battery when the Fluke-945 is not used for extended period.
OPEN
Battery Replacement
8