Table of Contents
Advertisement
Warnings
Contents
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
ProMix Network Interfaces . . . . . . . . . . . . . . . . . 3
ProMix Web Interface . . . . . . . . . . . . . . . . . . . . . . . 4
Local Network Connection . . . . . . . . . . . . . . . . . 4
Software Operation . . . . . . . . . . . . . . . . . . . . . . . 7
Web Navigation Screens . . . . . . . . . . . . . . . . . . . 8
Reports . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Warnings
The following general warnings are for the setup, use, grounding, maintenance, and repair of this equipment. Addi-
tional, more specific warnings may be found throughout the body of this manual where applicable. Symbols appear-
ing in the body of the manual refer to these general warnings. When these symbols appear throughout the manual,
refer back to these pages for a description of the specific hazard.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
•
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•
Do not exceed the maximum working pressure or temperature rating of the lowest rated system
component. See Technical Data in all equipment manuals.
•
Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all
equipment manuals. Read fluid and solvent manufacturer's warnings. For complete information
about your material, request MSDS forms from distributor or retailer.
•
Check equipment daily. Repair or replace worn or damaged parts immediately with genuine Graco
replacement parts only.
•
Do not alter or modify equipment.
•
Use equipment only for its intended purpose. Call your Graco distributor for information.
•
Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
•
Do not kink or over bend hoses or use hoses to pull equipment.
•
Keep children and animals away from work area.
•
Comply with all applicable safety regulations.
ELECTRIC SHOCK HAZARD
Improper grounding, setup, or usage of the system can cause electric shock.
•
Turn off and disconnect power at main switch before disconnecting any cables and before servicing
equipment.
•
Connect only to grounded power source.
•
All electrical wiring must be done by a qualified electrician and comply with all local codes and
regulations.
2
Modbus/TCP Kit Installation . . . . . . . . . . . . . . . . . 10
Variable Map . . . . . . . . . . . . . . . . . . . . . . . . 12
ProMix Auto Alarms . . . . . . . . . . . . . . . . . . . . . . 17
ProMix Auto Digital Inputs . . . . . . . . . . . . . . . . . 17
ProMix Auto Digital Outputs . . . . . . . . . . . . . . . 17
ProMix Auto Recipe Bits . . . . . . . . . . . . . . . . . . 18
ProMix Auto Color Change Steps . . . . . . . . . . . 19
Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Kit No. 15G634, Modbus/TCP Converter . . . . . 20
EasyKey Modbus / TCP Wiring Diagram . . . . . . . 21
Graco Standard Warranty . . . . . . . . . . . . . . . . . . . 22
Graco Information . . . . . . . . . . . . . . . . . . . . . . . . . 22
WARNING
311191C
Advertisement
Table of Contents
