Component Identification - Graco 245924 A Series Operation And Parts

Identifier Component
A Air Valve
B Flow Adjustment Nut
C Trigger
D Trigger Lock
E Material Fill Opening
F Handles
G Hopper
H Gun Plug
J Nozzle
K Hose Plug
M Air Fitting
N Clamp
P Gun Plug Clip
4

Component Identification

E
F
G
P
H
J
K
ti2441b
Adjusts air to material mix ratio.
Sets needle position.
Engages material flow.
Holds trigger open to assist operator during long jobs.
Where mixed material is loaded into hopper. For overhead applications and high walls, posi-
tion hopper on gun with material fill opening facing toward nozzle (J) (front) of gun. For all
other applications, material fill opening should face toward the air valve (A) (back) of gun.
Provided for operator comfort and relieve operator fatigue during long jobs.
Holds material.
Must be in place when material hose is used with texture pump system. To use hopper,
remove plug and install hopper as described on page 5.
Different sizes available for use with different applications, See Nozzle Selection chart, page
7.
Must be installed when hopper is used. This feature is not utilized in this application. See
Graco RTX manual for installation and operating instructions for this feature.
Quick Disconnect used to attach air hose to gun.
Secures hopper on gun.
Secures gun plug to gun.
A
N
M
B
D
C
Description
Component Identification
F
309584H