Removing A Unit From Storage; Trouble Shooting The Engine - EINHELL MT 24 Operating Instructions Manual

Anleitung MT 24-MTK 24 SPK 1
GB
combustion chamber. Pull starter rope slowly
several times to coat internal components.
Replace spark plug.
9. Store unit in a cool, dry place away from any
source of ignition such as an oil burner, water
heater, etc.
•

REMOVING A UNIT FROM STORAGE

1. Remove spark plug.
2. Pull starter rope briskly to clear excess oil from
combustion chamber.
3. Clean and gap spark plug or install a new spark
plug with proper gap.
4. Prepare unit for operation.
5. Fill fuel tank with proper fuel / oil mixture. See Fuel
and Lubrication Section.

Trouble shooting the engine

PROBABLE CAUSE
PROBLEM
Unit won't start or starts but will Incorrect starting procedures.
not run. Incorrect carburetor mixture
adjustment setting.
Fouled spark plug
Fuel filter plugged.
Unit starts, but engine has low
Incorrect lever position on
power. choke.
Dirty air filter.
Incorrect carburetor mixture
adjustment setting.
Incorrect carburetor mixture
Engine hesitates.
adjustment setting.
No power under load. Incorrectly gapped spark plug.
Runs erratically.
Smokes excessively. Incorrect carburetor mixture
adjustment setting.
Incorrect fuel mixture.
22
09.11.2004 15:19 Uhr Seite 22
CORRECTIVE ACTION
Follow instructions in the User
Manual.
Have carburetor adjusted by an
Authorized Service Center.
Clean / gap or replace plug.
Replace fuel filter.
Move to RUN position.
Remove, clean and reinstall filter.
Have carburetor adjusted by an
Authorized Service Center.
Have carburetor adjusted by an
Authorized Service Center.
Clean / gap or replace plug.
Have carburetor adjusted by an
Authorized Service Center.
Use properly mixed fuel (40:1
mixture).