Advertisement
5. THREE PAPER TRAY PEDESTAL KD-2009
The role of the pedestal is pretty obvious. The construction of the module is very simple. It
consists of 2 (model KD-1003) or 3 paper feed mechanisms, that are the same in construction.
What's more – they are the same as the standard feed module, located in the copier.
The only maintenance needed for this module is to clean the feed rollers with rubber
cleaning fluid and replace them when they are worn. The procedure for removing each module is
the same as for the one inside the copier. It was reviewed in the previous article about Toshiba
2060/3560 and 4560 models. However it is useful to know the layout and construction of the
pedestal. See figure 22:
Advertisement
