Advertisement
Adjustments:
1. Adjustment of skew (image inclination):
(1) Please confirm the installation as shown (RIGHT HINGE).
Note: Install the screw on the center of scale.
(2) Place the test original face up in the tray, press PRINT to make a copy.
Check that the copy isn't skew.
(3) If not, loosen the two screws on hinges and adjust the position of RIGHT HINGE. Repeat the
procedure until the copy isn't skew.
Note: After the adjustment, tighten the two screws of LEFT and RIGHT HINGE without fail.
2. LARGE CAPACITY FEEDER (LCF) MP-1501
As far as my experience goes – this is a very reliable module. I've hardly ever made repairs
on it, apart from the regular cleaning and repair of the pick up, feed and separation rollers.
Advertisement
