Quax HIP 05 05 32 Series Manual page 23

HIP
with drawer 05 05 32xx
4. Assembly of the changing table
Step 1 : Use both crossbars B, four wooden dowels T, the four legs A, the shelves C1S and C2L, four ec-
centrics R, four connectors S, twelve cylindrical nuts
Push two wooden dowels (T) into the lower drillings on the ends of both crossbars (B). Push two eccentrics
(R) into the drillings on the inside of the crossbars. Tighten a connector (S) in the hole on the inside of
each leg (A). Push the crossbars with their wooden dowels into the drilling and over the connector of two
legs. Push the other legs with their connectors into the drillings and over the wooden dowel of the cross-
bars. Tighten the eccentrics. Push eight cylindrical nuts (O) into the drillings at the bottom of the shelves.
Place the shelves between the legs, C1S above and C2L below. Push the bolts (M) into the drillings at the
front of the legs and tighten in the cylindrical nuts. Push four cylindrical nuts (O) into the drillings at the top
of the legs.
Luiertafel
Wickeltisch
O and eight bolts M
Table à langer
Diaper table
Quax Quax
First dreams First dreams
® ®
First steps First steps
23