Changing Stored Parameters In Pp2000 - IFM PP2000 Operating Instructions Manual

Changing stored parameters in the PP2000
No sensor is connected
for this operation.
Part 1:
Load parameters into
the working memory
page 20
1
nr0
nr1
nr2
nr3
Take the following steps:
• By selecting the memory location (SEL) you load the respective para-
meters from a read-only memory (nr1, nr2 or nr3) into the working
memory (nr0).
Part 1 / steps 1 - 3
The
working storaget contains the last sensor data record read. The data in
the working storage are automatically overwritten if
- a new sensor is connected or
- another data record is selected for modification by SEL.
• By programming you change the parameters in the working
memory.
Part 2 / steps 4 - 7
• By storing (Sto), you store the new parameters in the selected read-
only memory (nr1, nr2 or nr3).
The previous parameters at this location are overwritten.
Part 3 / steps 8 - 10
Switch on the
1
operating voltage
for PP2000
Mode/Enter Set
2
3
Mode/Enter Set
*A read-only memory with three memory locations is available: nr1, nr2, nr3.
2
nr0
Mode/Enter Set
nr1
nr2
nr3
The menu item SEL (selection of
the memory location) is displayed.
Press the Set button and keep
it pressed.
"nr0" flashes for 5s,
then the available memory
locations are displayed one after
the other*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the Mode/Enter button
briefly (= acknowledgement).
The selected parameters are in
the working storage and can be
modified.
3
nr0
nr1
nr2
nr3