Technical Data - Electrolux AEG EA 1 Series Operating Instructions Manual

822_949_282 EA120.book Seite 16 Montag, 2. April 2007 7:25 19
g
• the espresso is flowing out of the side
of the filter holder:
– Ensure that the filter holder has
been placed in the retainer correctly.
– Twist the filter holder a little more
firmly into the retainer.
– Clean any espresso grounds away
from the rim of the filter holder.
• no espresso is coming out:
– Ensure that the water tank has been
filled and is correctly in place.
– Ensure that the filter holder has
been placed in the retainer correctly.
– Ensure that the selector dial
(figure 1/E) has been turned right to
the position.
– Do not press the espresso grounds
too firmly into the filter.
– Clean the brew filter.
– Decalcify the appliance.
• the crema is no longer being produced
as it should:
– Ensure that there are enough
espresso grounds in the filter.
– Always use fresh espresso grounds.
– Press the espresso grounds lightly.
• too little milk froth is created when
steaming milk:
– Always use cool, fresh and low-fat
milk.
– Clean the steam nozzle.
• the flow increases:
– the espresso grounds have been
ground too rough:
– Ensure that there are enough
espresso grounds in the filter.
• the coffee machine switches itself off
while operating:
The appliance pump is equipped with a
temperature fuse that protects it from
overheating. The temperature fuse
interrupts the machine's operation, if
the machine is operated for too long or
if the pump is run without water.
– Set the on / off switch to "off" and
remove the plug from the mains
socket.
16
– Leave the machine to cool for at
least 20 minutes. Fill up with water.
– Plug the appliance into the mains
again and switch it on. If the
appliance still does not work, please
contact our Customer Care
Department.

Technical data

• Mains voltage: 230–240 V, 50 Hz
• Power consumption: 1250 W
(See rating plate on the underside of
the appliance.)
Disposal
2 Packaging material
The packaging materials are environ-
mentally friendly and can be recycled.
The plastic components are identified
by markings, e.g. >PE<, >PS<, etc.
Please dispose of the packaging mate-
rials in the appropriate container at
the community waste disposal faci-
lities.
2 Old appliance
W
The symbol on the product or on
its packaging indicates that this pro-
duct may not be treated as household
waste. Instead it shall be handed over
to the applicable collection point for
the recycling of electrical and electro-
nic equipment. By ensuring this pro-
duct is disposed of correctly, you will
help prevent potential negative conse-
quences for the environment and
human health, which could otherwise
be caused by inappropriate waste
handling of this product. For more
detailed information about recycling
of this product, please contact your
local city office, your household waste
disposal service or the shop where you
purchased the product.