Westfalia ZIR-ZK-125 Instruction Manual page 18

Take off the supporting table (5) and
unlock the drive spindle by pressing
the spindle lock (3) at the back of the
gear housing and release the flange
nut with the pin-type spanner key.
Remove the flange nut and pull off
the cutting discs
holders.
Replace the
assemble the new cutting discs and
the distance holders in order to
achieve the desired groove width.
Make sure the arrow on the cutting
discs corresponds to the rotational
direction of the machine (indicated
by an arrow on the protection cover
and on the gear housing).
The distance holders each have a width of approx. 3.5 mm. There are 6
distance holders available. Please note that the groove width is determined by
the sum of the distance holders plus the width of the cuttings discs (2 mm
each).
Finally assemble all parts of the machine in reverse order. Pay attention to the
tightness of the additional handle bar (10) and mounting screws.
and distance
cutting discs
Start-Up
and
13