Intended Use; Start-Up; Replacement And Set-Up Of Cutting Discs - Westfalia ZIR-ZK-125 Instruction Manual

Intended Use

The wall router cuts slots for cables and pipes in all kinds of brickwork and
concrete, provided that suitable cutting discs, as described in this manual, are
used.
The machine is suitable for dry cutting only.
This machine has been developed for private use and is not designed for the
demands of industrial use.

Start-Up

Make sure that the mains voltage corresponds to the rated voltage of this
machine. Units rated with 230 V also can be used with 220 V power networks
and vice versa.
Before connecting the machine to mains power, make sure that it is switch off
to prevent unintentional starting.
Press the On/Off switch (2) to switch on the machine. A control electronics unit
slowly starts the machine (soft start). The machine must have reached full
speed before you begin to slit.

Replacement and Set-up of Cutting Discs

Attention! Always disconnect the plug from the socket before carrying out any
work on the machine!
To remove the cutting discs or to setup the groove width, proceed as follows:
Unscrew the additional handle bar
(10). Pay attention to the left turn
thread. Remove
adjustment wheel
mounting screws from the protection
cover (4).
Start-Up
the depth
(6) and the
12