Symbols On The Machine - Zenoah G3800AVS Manual

8
(a)
(b)
(c)
(d)
(e)
(f)
English

4. Symbols on the machine

For safe operation and maintenance,
symbols are carved in relief on the
machine.
According to these indications, please
be careful not to make any mistake.
(a) The port to refuel "MIX GASOLINE"
Position: Fuel cap
(b) The port to top up chain oil
Position: Oil cap
(c) Setting the switch to the "O" position, the engine
stops immediately.
Position: Rear-left of the unit
(d) Starting the engine. If you pull out the choke knob
(at the back-right of the rear handle) to the point of
the arrow, you can set the starting mode as follows:
• First-stage position – starting mode when the
engine is warm.
• Second-stage position – starting mode when the
engine is cold.
Position: Upper-right of the aircleaner cover
(e) The screw under the "H" stamp is The High-speed
adjustment screw.
The screw under the "L" stamp is The Slow-speed
adjustment screw.
The screw at the left of the "T" stamp is the Idle
adjustment screw.
Position: Left side of the rear handle
(f) Shows the directions that the chain brake is
released (white arrow) and activated (black arrow).
Position: Front of the chain cover
■ EMISSION CONTROL
An emission control label is located on the engine.
IMPORTANT ENGINE INFORMATION
THIS ENGINE CONFORMS TO U.S. EPA PH1
FOR SMALL OFF-ROAD ENGINES.
COMPLIANCE PERIOD : CATEGORY A
ENGINE FAMILY : 7KZXS.0374BC ; EM
ENGINE DISPLACEMENT : 37cc
REFER TO OWNER'S MANUAL FOR MAINTE-
NANCE, SPECIFICATIONS AND ADJUSTMENTS.
MANUFACTURED:
ZENOAH CO.,LTD.
USE JASO FC OR ISO EGC GRADE 50:1 OIL.
*1: The initial number will be changed every year of
manufacturing.
*1