HAZARD! ALWAYS GUIDE THE
APPLIANCE THROUGH THE WORK-
PIECE IN REVERSE ROTATION .
►
In the opposite direction there is a risk of kick-
back . The appliance can be pushed out of
the cut .
■
Always switch the appliance on before
applying it to the workpiece. After completing
the task, lift the appliance from the workpiece
and then switch it off .
■
Always hold the appliance firmly with two
hands while working. Ensure that your stance
is secure and stable .
■
For an optimum grinding effect, move the
appliance evenly at an angle of 15° to 30°
(between grinding disc and workpiece) back-
wards and forwards .
■
When working on angled surfaces, do not
exert great force on the workpiece. If the rota-
tional speed drops significantly, you must re-
duce the pressure exerted to allow safe and ef-
fective working . If the appliance suddenly
brakes completely or jams, it must be switched
off immediately .
■
Cutting: Work at a moderate feed rate and
do not tilt the cutting disc.
PWS 230 D4
■
Roughing and cutting discs become very
hot – let them cool down completely before
touching them.
■
Never use the appliance for purposes other
than the ones for which it was designed.
■
Always make sure that the appliance is
turned off before plugging it into the wall
socket.
■
In case of danger, remove the plug from the
socket immediately. Ensure that the appliance
and the power socket are easily and quickly
accessible in the event of an emergency .
■
Always remove the plug from the power sock-
et during work breaks, when adjusting the
appliance and when it is no longer in use.The
appliance must be kept clean, dry and free of
oil and grease at all times .
■
Remain alert at all times! Always pay atten-
tion to what you are doing and act with com-
mon sense. Do not use the appliance if you are
distracted or feeling unwell .
WARNING!
Always wear safety googles.
WARNING!
Always wear a dust mask!
GB │ IE │ NI │ CY
│
9
■