Table of Contents
Advertisement
Operation
1. Before starting work, make sure the EMERGENCY STOP switch (I) is in the
OFF position.
2. The winch is equipped with two automatic turn off switches, witch turn off the
winch on the upper and lower stop. The switch L stops the winch on the upper
stop; the switch L stops the winch when the cable is fully extended.
3. Three winds of the steel cable remain on the steel cable drum (G) when the
winch turns off in fully unwound position. This is necessary for safety reasons.
4. Switch on the cable winch by using the toggle switch (E) and press it to that
direction you intent to move the load. Do not switch straight from lower to
raise, but stop the machine in between.
By pressing the EMERGENCY STOP switch (I) you can immediately stop the
cable winch. In order to switch on again, turn the EMERGENCY STOP switch
counter clockwise until the switch lifts up.
Operation
11
Advertisement
Table of Contents
