Basic Tv Connections; Optional Tv Connections - Zenith XBS344 Installation And Operating Manual

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on
the capabilities of your TV.
RF coaxial connection
Connect the RF.OUT jack on the DVD/VCR Receiver to
the antenna in jack on the TV using the 75-ohm Coaxial
Cable supplied (R).
ote
If you use this connection, tune the TV to the DVD/VCR
Receiver's RF output channel (CH 3 or 4).
How to set the DVD/VCR Receiver's RF output chan-
nel
While the DVD/VCR Receiver is turned off, press and
hold CH/PRESET (v/V) on the front panel for about five
seconds to change the RF output channel (CH 03 or
CH 04). "RF 03" or "RF 04" appears in the display win-
dow.
Audio/Video connection
1 1
Connect the DVD/VCR VIDEO OUT jack on the
DVD/VCR Receiver to the video in jack on the TV
using the supplied video cable (V).
2 2
Connect the Left and Right DVD/VCR AUDIO OUT
jacks on the DVD/VCR Receiver to the audio
left/right in jacks on the TV (A) using the supplied
audio cables.
ote
If you use this connection, set the TV's source selector
to VIDEO.
Typical TV Connections Panel
ANTENNA
VIDEO
AUDIO INPUT
INPUT
INPUT
L R L
A V
R
DVD+VCR Connections Panel
12
COMPONENT/PROGRESSIVE S-VIDEO
SCAN VIDEO INPUT
INPUT
Pr Pb Y
C S

Optional TV Connections

ote
The S-VIDEO OUT and COMPONENT/PROGRESSIVE
SCAN VIDEO OUT connection options below only work
with DVD playback. The tuner and VCR will still output
through the RF.OUT (R) or DVD/VCR OUT (A, V) jack.
(See left)
S-Video Connection
1 1
Connect the S-VIDEO OUT jack on the DVD/VCR
Receiver to the S-Video in jack on the TV using the
supplied S-Video cable (S).
2 2
Connect the Left and Right AUDIO OUT jacks on
the DVD/VCR Receiver to the audio left/right in
jacks on the TV using the supplied audio cables
(A).
Component Video (Color Stream
1 1
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD/VCR Receiver to the
corresponding in jacks on the TV using user-sup-
plied Y Pb Pr cables (C).
2 2
Connect the Left and Right AUDIO OUT jacks of
the DVD/VCR Receiver to the audio left/right in
jacks on the TV (A) using the supplied audio
cables.
Progressive Scan (ColorStream
If your television is a high-definition or "digital ready"
television, you may take advantage of the DVD/VCR
Receiver's progressive scan output for the highest
video resolution possible.
If your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you try
Progressive Scan on the DVD/VCR Receiver.
1 1
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD/VCR Receiver to the
corresponding in jacks on the TV using an optional
Y Pb Pr cable (C).
2 2
Connect the Left and Right AUDIO OUT jacks of
the DVD/VCR Receiver to the audio left/right in
jacks on the TV (A) using the supplied audio
cables.
otes
– Set Progressive Scan to "On" on the DVD setup
menu for progressive signal, see page 21.
– Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack).
® ) connection
pro) connection
®