Using Lille Viking; Main Power Switch; Manual Release Handle - Etac Lille Viking 2000+ Manual

Etac / Lille Viking / www.etac.com
4.2 Symbols
1
1. Anchoring point
2.
Maximum speed 6 km/h
3. Maximum user weight 150 kg
For you to be able to benefit fully and enjoy Lille Viking 2000 supporting motor in combination with manual wheelchair, as well as to
ensure correct and safe use, we ask you to read these instructions carefully.

5.1 Main power switch

Notice that the on/off-switch is marked with a red and yellow circle.
1. To turn on the power to the supporting motor, twist the key clockwise, from position.
2. Turn on the ON/OFF knob on the control box (pos 6, p. 8/9). Use the same knob to adjust the speed.
3. You will now see a green light. This means that the auxiliary motor is turned on and ready for use.
• To turn off the power to the supporting motor, twist the key counter clockwise.
1
Before you start using the supporting motor, check the brakes on the wheelchair and make sure that they are disconnected.

5.2 Manual release handle

Risk of crushing! Take care when using the manual release handle.
The manual release handle has three positions.
1. Operating position - in this position the auxiliary motor is pushed down against the surface, ensuring that the motor moves the wheel-
chair forward and that the braking effect is maintained.
2. Mounting position.
3. Manual release position - the auxiliary motor is elevated and suspended and does not affect the wheelchair.
1
2 3

5. Using Lille Viking

2
2
4
Outlet, control unit. The label lists the control units that are
4.
compatible with the auxiliary motor. Models that are not listed
may not be used in combination with the auxiliary motor.
5. Outlet, battery charger
40
5
3
3