Operating Sequence; Washing; Load The Laundry; Measure Out The Detergent - Zanussi 1262 W Instruction Booklet

Operating Sequence

WASHING

Before the first wash, we recommend that you pour 2
litres of water into the main wash compartment
the detergent drawer in order to activate the ECO valve.
Then run a cotton cycle at 95°C, without any laundry in
the machine, to remove any manufacturing residue from
the drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment of the dispenser drawer and start the
machine.

1.Load the laundry

Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.

2.Measure out the detergent

Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment
If you wish to carry out the prewash or the soak
programme, pour detergent into the appropriate
compartment marked
3.Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
Close the drawer gently.
4.Switch the machine on and
.
.
select the desired programme
Turn the selector dial to the desired programme to
of
switch the appliance on. The display will show the
duration of the selected programme. The "Start/Pause"
button light will start flashing.
To switch the appliance off turn it to "O" Off position.
5. Select the spin speed or the
RINSE HOLD option
Press the "Spin" button repeatedly, in order to select the
desired spin speed or the
relevant light will light up.
If you select the
will stop at the end of the programme with the water
still in the tub.

6. Select the desired options

Depress the relevant buttons to select the required
options. The corresponding light illuminates.
10
"Rinse Hold" option. The
"Rinse Hold" option, the machine