Installation - Tekno Point ELSKOV-12 Use And Installation Manual

INSTALLATION

4. INSTALLATION
4.1 PLACE OF INSTALLATION
The installation location should be agreed with the customer,
paying attention to the following points:
- The equipment should be placed in a technical room of
adequate size and in accordance with applicable regulations
in the countries where it will be installed.
- The condensing unit must not be installed outdoors.
- The plan on which will be supported to be able to support
the weight, the rubber feet that is attached to the machine
SHOULD NOT BE REMOVED except in case of use of anti-
vibration spring for installations with wall bracket.
MINIMUM DISTANCES TO BE RESPECTED
FRONT
30 cm
4.2 INSTALLATION MODE ELSKOV-12 H9
invisible unit
Maximum distance from the wall: 4 linear meters, 8 m long
version. 2 holes Ø 200 mm, rigid pipe.
30 cm
Air output
Inlet air
perimeter wall
- The front panel must be inspected, so the front space
should be adequate to permit the operator with all the steps
required during installation, maintenance and assistance
(controls, adjustments, refrigerant charge).
- In case of multiple installations (2 or more ELFO) DO NOT
STACK the condensing units.
- The installation must allow authorized personnel to
intervene in case of maintenance, in an easy manner which
respects both the safety distances between the unit and
other equipment that the technical areas mentioned below:
TOP
50 cm
10 cm
Maximum distance from the wall: 4 linear meters, 8 m long
version. 1 hole Ø 200 mm inlet equipment room min 150
mm, rigid pipe.
INS
50 cm
invisible unit perimeter wall
USE AND INSTALLATION MANUAL ELFO
CAT
Air output
26