Motorola Avigilon ACC VMA-RPA-RGD-8P2 User Manual page 44

5. Removing the SSD:
a. With your index finger behind the blue tab, use a small amount of force to pull the tray out of
appliance. Opening the tray physically disconnects the SSD from the appliance.
Important: Wait approximately 10 seconds until the Status changes to
indicates that the appliance has detected the removal of the SSD, before
proceeding.
b. Lift the tray out of the sliding drawer.
c. Remove the four screws that attach the SSD to the tray. Safely store them to reatttach the
replacement SSD.
d. Remove the SSD from the tray.
The status of the SSD in the Storage panel of the web interface launch page remains
SSD is removed.
6. Inserting the SSD:
a. Place the SSD in the tray.
b. Attach the replacement SSD to the tray.
Use the four screws stored after removing the original SSD.
c. Put the tray onto the sliding drawer.
d. Push the blue tab inwards until you hear a faint click as the SSD physically connects to the
appliance.
The status of the SSD in the Storage panel of the web interface launch page changes to
the SSD is physically reconnected the status changes to
7. Restore the most recent backup of the ACC system settings, or configure the ACC ES Rugged 8-Port
Appliance as though newly installed. For more information on backing up the ACC system settings,
see the AvigilonACC Client User Guide
8. Install the latest version of the appliance firmware if a newer version is available. For more
information, see Upgrading the Firmware on
9. Reactivate all the licenses used on the ACC ES Rugged 8-Port Appliance. For more information on
activation of site licenses, see the ACC Help or the Avigilon ACC Client User Guide.
Important: If you cannot reactivate the licenses, contact Avigilon Technical Support at
avigilon.com/contact.
Replacing the Storage SSD
.
page 36.
, which
while the
. When
44