At+Dlmt - CipherLab 8400 GPRS Cradle Reference Manual

AT+DLMT

Read Command
AT+DLMT?<CR>
Example
AT+DLMT?
ENABLE:0x0d
AT+DLMT?
DISABLE
Write Command
AT+DLMT=[Parameter](,HEX)<CR>
Example
AT+DLMT=1,0x0a
OK
AT+DLMT=1
ERROR
AT+DLMT=0
OK
Remarks
The Read command is to get the delimiter check status. [HEX] is a character in hexadecimal, with
the prefix "0x".
The Write command is to set the delimiter check, enable or disable. [Parameter] is a character
that determines whether a delimiter character is applied —
Parameter =0: Disable delimiter
Parameter =1: Enable delimiter
When Parameter =1, [HEX] is a character in hexadecimal, with the prefix "0x". For example,
"0x0d" for Carriage Return (CR).
See Also
ATDT
Back to the Supported AT Commands.
Appendix II
Response
<CR><LF>ENABLE:[HEX]<CR><LF>
<CR><LF>DISABLE<CR><LF>
Delimiter check
character "0x0d" is currently in use.
No delimiter check.
Response
<CR><LF>OK<CR><LF>
<CR><LF>ERROR<CR><LF>
Enable delimiter check successfully, and
the character "0x0a" is in use.
Command syntax is incorrect!
Disable delimiter check successfully.
AT Commands
is applied, and the
53