Table of Contents
Advertisement
INSTALLATION
1) Screw the antenna to the cradle.
2) Open the rubber cover at the back of the cradle.
3) Insert your SIM card and replace the rubber cover.
The SIM card orientation is as shown in the illustration above, with contacts facing
down. Refer to Chapter 3
4) Seat the mobile computer in the cradle.
5) Connect the power supply cord to a suitable power outlet, and the cradle's POWER
indicator will become red after flashing for a few seconds. The cradle is ready for
charging the mobile computer.
Note: You will need pliers to take out your SIM card when it is not desired in use. Always
disconnect the power supply cord before removing the SIM card.
Using 8400 to Configure GPRS
Introduction
Cradle.
3
Advertisement
Table of Contents
