Table of Contents
Advertisement
Note: After powering on, the POWER indicator will start to flash in a few seconds,
indicating the cradle is in initialization process. Then, two conditions are
encountered: (1) If the POWER indicator keeps flashing, it means initialization fails
due to incorrect PIN; (2) If the POWER indicator becomes solid, it means
initialization is done successfully – correct PIN or PIN not required.
12) Go to 1. Settings > 3. Download to download your settings to the cradles.
13) Disconnect the power supply cord.
14) Re-connect the power supply cord.
Note: After powering on, the POWER indicator will start to flash in a few seconds,
indicating the cradle is in initialization process. Then, two conditions are
encountered: (1) If the POWER indicator keeps flashing, it means initialization fails
due to incorrect PIN; (2) If the POWER indicator becomes solid, it means
initialization is done successfully – correct PIN or PIN not required.
15) Perform echo tests if necessary.
Chapter 3
Using 8400 to Configure GPRS Cradle
17
Advertisement
Table of Contents
