Table of Contents
Advertisement
ATF
Execution Command
ATF<CR>
Example
ATF
OK
Remarks
This command is to load factory defaults, as shown below.
Parameters
unsigned char PINCode[9]
unsigned
GPRSAccessPoint[21]
GPRS_FLAG Flag
unsigned int Reserved:14
unsigned int DelimEnable:1
unsigned int CHAPEnable:1
char CHAPPassword[33]
char CHAPUserName[33]
char DelimiterChar
int DhcpEnable
unsigned char IpAddr[4]
See Also
ATW
Back to the Supported AT Commands.
Defaults
Description
'0000'
PIN (Personal Identity Number) of SIM card; an
access code of 4~8 digits
char
internet
AP name for GPRS
See GPRS_FLAG structure below.
---
0
0
Null
Password for Challenge Handshake Authentication
Protocol (CHAP)
Null
User
Authentication Protocol (CHAP)
0x0d
Delimiter Character
1
0: Disable DHCP
1: Enable DHCP
0,0,0,0
Static IP address for the cradle
Appendix II
Response
<CR><LF>OK<CR><LF>
---
Enable checking the delimiter character
0:Disable
1:Enable
Challenge Handshake Authentication Protocol
0:Disable
1:Enable
name
for
AT Commands
Challenge
Handshake
45
Advertisement
Table of Contents
